How to connect to a Veeder-Root TLS-450 Plus
On the console, use menu to retrieve communication settings.
- Select Menu from the Home screen
- Select Setup
- Select Communications
Select Serial Port
- Configured = Enabled
- Label = Enter a name or leave blank
- Usage = RS-232 (Important!)
- Baud Rate = 9600
- Data Bits = 7
- Parity = ODD
- Stop Bits = 1
Connecting the PDS hardware to the TLS-450 Plus
1. Connect the appropriate connector/adapter to the ATG's serial port
(Connect the gray 3-pin DB9 male adapter to an available serial port on the bottom of the ATG.)
2. Connect the black DB9 female adapter into the serial port on the PDS hardware device.
3. Connect the included ethernet cable to each adapter.
4. Contact us to confirm communication settings and connectivity.
